Fossil TY2723 Manual Del Usuario página 3

Automatic Winding Movement
A timepiece fitted with an automatic winding movement obtains the power to wind itself by the movement
of your wrist, there is no battery . Therefore, not wearing the timepiece for several consecutive days could
exhaust the power reserve . If your watch stops, it is recommended that you manually wind the movement by
rotating the crown clockwise to achieve the necessary power reserve .
It is important your timepiece is adjusted to match the size of your wrist . A loose fit may result in a loss
in capacity of the timepiece to wind itself . When fully wound, your timepiece has a power reserve of
approximately 38 hours .
Automatic TY2723 / TY2542
1 . To start time-keeping, rotate the crown
clockwise 15-20 times in position 1 .
2 . Pull crown out to position 2 and rotate
clockwise to set time . Push crown back
to position 1 .
Automatic TY2527
1 . To start time-keeping, rotate the crown clockwise 15-20
times in position 1 .
2 . Pull crown out to position 2 and rotate clockwise to set
time . Push crown back to position 1 .
3 . Press A to set weekday .
4 . Press B to set date .
5 . Press C to set month .
NOTE: Each press of the pushers will advance the values by one increment.
2
POWER
RESERVE
SECONDS
SECONDS
TY2723
TY2542
MONTH
B
DATE
DAY
A C
Automatic TY2510
1 . To start time-keeping, rotate the crown clockwise 15-20 times in position 1 .
2 . Pull crown out to position 2 . Rotate counter-clockwise to set hour in time
zone 2 .
NOTE: Time zone 1 hour and minute hands will also turn.
3 . Rotate crown clockwise to set hour and minute hands in time zone 1 .
NOTE: Time zone 2 minute hand will also turn.
4 . Return crown to position 1 .
Retrograde with Date Sweep VD86A
Time and Date Setting
1 . Pull crown out to position 3 and rotate clockwise to set day of week .
Hand in upper left indicates weekday and will automatically reset to
"M" at the end of the week .
2 . Keeping crown in position 3, rotate hands to set the time (make sure
am/pm is set correctly) .
3 . Push crown back to position 1 .
4 . Pull crown out to position 2 and rotate counter-clockwise to set date .
5 . Push crown back to position 1 .
Two Eye Multifunction 6P25
Date Setting
1 . Pull crown out to position 2 .
2 . Turn counter-clockwise to select date .
Day and Time Setting
1 . To set time, pull crown out to position 3 .
2 . Turn clockwise to set hour and minute hands . The hand showing days of the week will also move with the
hour and minute hands . Keep turning until you have reached the desired day .
3 . Push crown back to position 1 .
TiME zONE 2
DATE
DAY
3