S
AUDER WELCOMES YOU TO THE WORLD OF READY- -TO- -ASSEMBLE FURNITURE
A
SSEMBLY IS QUITE SIMPLE IF YOU FOLLOW OUR STEP- -BY- -STEP INSTRUCTIONS
U
NPACK PARTS CAREFULLY TO PREVENT SCRATCHING OF THE FINISHED PIECES
D
O NOT BEGIN ASSEMBLY UNTIL YOU ARE FAMILIAR WITH THE PARTS
E
XTRA TIME SPENT DURING THE ASSEMBLY WILL BE WELL WORTH IT
R
EADY . . . . SET . . . . GO
PARTS IDENTIFICATION
Each part for this unit may not have a label or inked letter on it. Parts are labeled or inked on the edge to help
distinguish similar parts from each other. Use this PARTS IDENTIFICATION to help identify similar parts.
(A) OUTER
END - - 1
(E) TOP - - 1
(I) RIGHT
MOLDING - - 1
109872
(B) INNER
(J) LEFT
(K) SHORT
MOLDING - - 1
(C) RIGHT
END - - 1
(F) MODESTY
PANEL - - 1
(L) END
MOLDING - - 1
MOLDING - - 2
CFCs
The polystyrene foam used in Sauder
packaging contains no CFCs which
are known to reduce stratospheric
ozone layers.
(D) LEFT
UPRIGHT - - 1
(G) SHELF - - 1
(H) BOTTOM - - 1
(M) LONG
SKIRT - - 2
UPRIGHT - - 1
(N) SHORT
SKIRT - - 2