Publicidad
5
Be sure the METAL
BRACKET (U) on each
LONG SKIRT (M) is
positioned toward the
floor.
FOOT (R)
SHORT
SKIRT (N)
- Position both LONG SKIRTS (M) and both SHORT SKIRTS (N) on edge as shown.
NOTE:
Be sure the METAL BRACKET (U) on each LONG SKIRT is positioned toward the floor. Be sure
the grooves in the SKIRTS are facing in as shown. Follow the diagram closely.
- Slide two FEET (R) into the grooves in the LONG SKIRTS (M) and SHORT SKIRTS (N) as shown. You may need to
gently tap them in with your hammer. Follow the diagrams closely.
- Now, fasten the FEET (R) to the BOTTOM (H) as shown. Use a 9/16" WAFER HEAD SCREW (AA) through the
large hole in each FOOT and into the pre- -drilled holes in the BOTTOM.
NOTE:
Be sure to use the 9/16" WAFER HEAD SCREWS (AA). Start both SCREWS a few turns before
tightening either of them.
- Next, fasten the METAL BRACKET (U) on each LONG SKIRT (M) to the BOTTOM (H). Use a 9/16" LARGE
HEAD SCREW (BB) through each METAL BRACKET and into the pre- -drilled holes in the BOTTOM.
NOTE:
Be sure to use the 9/16" LARGE HEAD SCREWS (BB).
109872
FOOT (R)
LONG
SKIRT (M)
BOTTOM (H)
Unfinished
surface
www.sauder.com/services
SHORT
SKIRT (N)
9/16" LARGE HEAD SCREW (BB)
(2 used for the METAL BRACKETS)
9/16" WAFER HEAD SCREW (AA)
(2 used for the FEET)
Publicidad
