Publicidad
14
FOOT (R)
BOTTOM (H)
INNER
END (B)
OUTER
END (A)
1- -7/8" FLAT HEAD SCREW (X)
- Fasten the BOTTOM (H) to the OUTER END (A) and INNER END (B) as shown. Use four 1- -7/8" FLAT HEAD
SCREWS (X) through the BOTTOM and into the pre- -drilled holes in the edges of the ENDS.
NOTE:
Be sure the FEET (R) are facing up. Follow the diagram.
- Next, fasten the support bracket (from the 109848 Return Kit) to the TOP (E) and MODESTY PANEL (F) as shown.
Use three 9/16" LARGE HEAD SCREWS (from the 109848 Return Kit) through the bracket and into the pre- -drilled holes
in the TOP and MODESTY PANEL.
NOTE:
The longer arm of the bracket should be fastened to the MODESTY PANEL. Use one pre- -drilled
hole in the TOP and two pre- -drilled holes in the MODESTY PANEL.
- Now, finish fastening the support bracket to the TOP (E) and MODESTY PANEL (F). There are three remaining holes
in the bracket. Turn three 9/16" LARGE HEAD SCREWS (from the 109848 Return Kit) through these holes and into the
TOP and MODESTY PANEL.
NOTE:
There are no pre- -drilled holes for these three SCREWS. Use a little extra force to get
them started.
109872
RETURN KITS ON RIGHT
FOOT (R)
(4 used in this step)
www.sauder.com/services
MODESTY
PANEL (F)
TOP (E)
Support Bracket
(from the 109848 Return Kit)
9/16" LARGE HEAD SCREW
(6 used for the bracket)
(from the 109848 Return Kit)
Publicidad
