Publicidad
12
OUTER
END (A)
Finished
surface
SHORT
MOLDING (K)
- Fasten the SHORT MOLDING (K) to the TOP (E) as shown. Use two 1- -1/8" FLAT HEAD
SCREWS (CC) through the holes in the SHORT MOLDING and into the pre- -drilled holes in the TOP.
NOTE:
Line up the corners of the MOLDINGS before tightening the SCREWS.
IMPORTANT:
Do not overtighten the SCREWS. The heads of the SCREWS should be even with the
surface of the MOLDING.
109872
RETURN KITS ON RIGHT
TOP (E)
www.sauder.com/services
1- -1/8" FLAT HEAD SCREW (CC)
(2 used in this step)
Publicidad
