2. Push the filter holder (22) with the permanent filter (20) fully in without coffee powder.
3. Place the glass pot (18) with the lid (19) on the hot plate (17).
4. Then switch the appliance on.
5. Wait until approx. one cup has run through and switch off the appliance.
6. Let the descaling solution take effect for around 15 minutes and then switch the
appliance back on again.
7. Repeat steps 5 and 6 once, then leave the appliance switched on until the descaling
solution has run through fully.
8. Then repeat the running-through process three times with clear water.
9. Rinse the glass pot (18), lid, coffee filter holder (22) and permanent filter (20)
thoroughly under running water.
10. Activate the drip stop (21) several times during rinsing.
7.2
Care of stainless steel parts
For regular care and also for removing stubborn stains on stainless steel parts we
recommend the INOX METAL POLISH from Beem. This polish restores the original sheen
to appliances. INOX METAL POLISH is available in tubes and is suitable for all objects
made of stainless steel, chrome, brass, copper, aluminium, silver and also hard plastics.
INOX METAL POLISH is also used in factories for polishing stainless steel. You can order
INOX METAL POLISH from your specialist dealer, by telephone from us or on our website
www.beem.de.
Please note that the label and imprint on the stainless steel surfaces may come off if
cleaned with metal polish or other chemicals.
7.3
Storage
Let the appliance cool down fully.
Empty the kettle (11) and the water tank (15).
BEEM – Elements of Lifestyle
32 / 88