Preparation For Operation - GRAPHITE 59G770 Instrucciones De Uso

Use the tool according to its intended purpose only.
DESCRIPTION OF THE DRAWINGS PAGES
The enumeration below refers to the parts of the device shown in the drawing pages of this manual.
1. Abrasive (sanding) belt
2. Abrasive belt tension lever
3. Sanding arm position locking lever
4. Abrasive belt speed control knob
5. Switch lock button
6. Switch
7. Dust bag
8. Carbon brush cover
9. Sanding arm clamp knob
10. Sanding arm
11. Guide roller
12. Dust discharge connection
* The actual product may slightly differ from the drawing.
MEANING OF SYMBOLS
CAUTION
WARNING
INSTALLATION/SETTINGS
INFORMATION
EQUIPMENT AND ACCESSORIES
1. Sanding arm (straight + curved)
2. Sanding arm clamp knob + spring
3. Dust bag
4. Abrasive belt
5. Carrying case
INSTALLATION AND REMOVAL OF SANDING ARM
● Place the sanding arm (10) in the guide, inserting a spring between the two elements.
●
Tighten the clamp knob to secure the sanding arm (
INSTALLATION OF ABRASIVE BELT
Before installation of the abrasive belt make sure the switch is in the off position and the power cord
is disconnected from the mains.
● Move the abrasive belt tension lever (2) all the way in the forward direction (Fig. B).
●
Put the abrasive belt on the rollers.
●
Move the abrasive belt tension lever (
ABRASIVE BELT CHECKING
If the same abrasive belt is used for a prolonged period of time, its performance gradually decreases.
Therefore, the abrasive belt should be replaced as soon as excessive wear is noticed.
- 2 pcs
- 1 set
- 1 pc
- 4 pcs
- 1 pc

PREPARATION FOR OPERATION

2) to its initial position.
13
9) (Fig. A).