Installation Steps - AVS Bugflector Instrucciones De Instalación

Installation Steps

Center one (1) long strip of protective film along the lead-
ing edge of the hood. Wrap the protective film along the
hood edge. DO NOT COVER HOLES.
3
Center one (1) long strip of protective film along the
leading edge of the outer grille housing. Place the pro-
tective film along the TOP of the housing.
B
5
Press (4) hood inserts into the (4) square holes. If
necessary use tape to hold them firmly in place.
7
Using a phillips screwdriver install (4) screws with (4)
washers at the locations noted in Step 6.
square hole
hood
hood insert
hood shield
washer
screw
9
DO NOT OVER TIGHTEN
NOTE: Actual application may vary slightly from illustrations.
A
Wrap two (2) short pieces of protective film around the
leading edge of the hood closest to the headlights
C
4
Note the location of the (4) square holes.
6
Align pre-drilled holes in hood shield with holes in hood. Place
hood shield on hood, ensuring protective fim is between the hood
shield flange and hood edge.
8
Note the location of the (2) remaining holes.
10
Page 2 of 3
D