Access The Cervical Traction Assembly - Hillrom Allen A-71101 Manual Del Usuario

ACCESS THE CERVICAL TRACTION ASSEMBLY

The cervical traction release control is a push button on the upper-left side
of the head-end column.
Push the cervical traction release
button. The assembly moves out from
the column.
Pull the assembly out from the
column, and make sure the assembly
is in the locked-out position. The
cervical traction release button will
return to its original position.
WARNING:
The maximum diameter of the traction rope should be
6.35 mm (0.25"). The use of a traction rope that is greater
than 6.35 mm (0.25") in diameter could cause binding inside
the cervical traction assembly. Patient injury could occur as
a result of inaccurate traction.
Put the traction rope through the hole
in the center of the bowtie. The rope
will go through the traction assembly
and out the left side of the column,
near the release.
Put the traction rope over and around
the pulley.
If desired, install the optional cervical
traction bar on the support top-side of
the head-end H-bracket as follows:
a. Determine the hole location for
the cervical traction bar.
NOTE:
The hole locations are numbered on
the side of the H-brackets.
Allen® Advance Table User Manual (D-720761 Ver D)
Instructions for Use
41