Descaling Procedure - Barazza 1FVCFY Manual De Instrucciones

EN
Care and maintenance

Descaling procedure

Warning: For safety reasons, the descaling
process cannot be interrupted.
The appliance has to be descaled with the
appliance door closed. The appliance must be in
idle state prior to starting the descaling cycle.
To run a descaling cycle proceed as follows:
1. Press the Descale key during 5 seconds. The
display shows
intermittent beep. (In case you don't want to go
ahead with the descaling procedure press the
Stop key, or just wait for about 5 seconds
without pressing any key).
2. Press the Start key.
3. When the display shows "0.5L", remove the
water tank.
4. Pour 0.5 litres of an adequate descaling
solution into the water tank and put the water
tank back.
5. Press the Start key. The Descale cycle is
initiated and takes about 30 minutes.
30
"CAL" and there
6. When the Descale display shows "1L" flashing
and the oven emits a beep, remove and empty
the water tank.
7. Fill the water tank with 1.0 litres of cold water
and put the water tank back.
8. Press the Start key. The first rinsing cycle
is an
starts.
9. When the Descale display shows again "1L"
flashing and the oven emits a new beep,
remove and empty the water tank.
10. Fill the water tank with 1.0 litres of cold water
and put the water tank back.
12. Press the Start key. The second rinsing cycle
starts.
13. When the rinsing cycle has finished the
display shows "End".
14. Remove, empty and dry the water tank.