Safety Thermostat - Sime SOLIDA 5 PL Manual De Instrucciones

2.5 CLEANING (fig. 19)
Cleaning operations must be carried out
at regular intervals and only when the
boiler is cold.
Combustion residuals collect in the
removable drawer that must be emptied
before starting the boiler.
ATTENTION: To release and open the
bottom door, lift the locking bracket (A).
To remove all combustion residuals, use
an ordinary aspirator and verify that all
the ashes inside the combustion cham-
ber have been completely removed.
The aspirator can also be used to clean
the fuel grille.
To clean the fume ducts inside the boiler
body, use a wiper.
ATTENTION: if the generator is switched
off for long periods of time (above 15
days), it is necessary to empty the pellet
container in order to prevent the pel-
lets from absorbing excessive humidity,
which could affect the operation of the
boiler. A high amount of humidity in the
pellets could cause them to pulverize,
increase the amount of residuals in the
brazier and obstruct the pellet feeding
system.
2.6

SAFETY THERMOSTAT

(fig. 20)
The safety thermostat with manual reset
intervenes automatically, switching off
the burner, when the water heater tem-
perature exceeds 95°C.
To start the water heater back up again,
press the button as shown in the figure.
During the resetting procedure one must
not remove the bracket that protects the
thermostat.
If this event occurs frequently, have
qualified staff inspect the equipment.
2.7 ANNUAL
MAINTENENCE
For optimum performance, it is advis-
able to have the boiler inspected accu-
rately and thoroughly by qualified per-
sonnel at least once every season.
24
A
Before performing maintenance opera-
tions, verify that the boiler is cold and
has been disconnected from the mains.
2.7.1 Warnings
In the event of product failure and/or
malfunction, switch it off and do not
attempt to repair or intervene on it.
Any repairs must be carried out by
authorised staff using original spare
parts.
2.8 DEMOLITION AND
DISPOSAL OF THE
Fig. 20
APPLIANCE
(2012/19/UE)
of with domestic waste. It can be taken
Removable
drawer
At the end of its life cycle
the appliance MUST BE
DISPOSED AND
RECYCLED, as required by
current law.
It MUST NOT be disposed
Fuel grille
to waste recycling centres, where they
exist, or to a dealer providing this ser-
vice.
Recycling waste prevents potential
damage to the environment and harm
to health. It also allows you to recover
many recyclable materials with signifi-
cant economic and energy savings.
2.9 ACCESSORIES
The available accessories to be ordered
separately:
- code 5197500 200-litre PELLET
TANK (1081 x 440)
- code 5197510 300-litre PELLET
TANK (1381 x 440)
- code 5197520
500-litre PELLET
TANK (1481 x 640)
Fig. 19