Set Up - Timberpro M2600-3 Manual Del Propietário

5. Set up

INSTALLING CUTTING ATTACHMENT GUARD
• Put the cutting attachment guard on the gearbox, at-
tach it with the 2 screws and hardware provided.
BRUSH CUTTER AND EDGE TRIMMER
INSTALLING METAL BLADE
1- Place the collar ring (3) on the shaft thread.
2- Insert the key wrench (1) into the gear
case locking hole.
3- Secure metal blade (4) between collar ring (3)
and washer (5).
4- Place the washer (6)
5- Screw the nut (7).
INSTALLING THE
CUTTER HEAD)
1- Place the collar ring (3) on the shaft thread.
2- Insert the key wrench (1) into the gear case
locking hole.
3- Screw the nylon spool (8) on the shaft thread.
4- Check the spool is secured tightly
8
HARNESS
WARNING
ALWAYS WEAR THE PROVIDED HARNESS WHEN
USING THE MACHINE!
Always make sure the machine is hooked securely
to the harness.
If you don't, you will be unable to control the machine
safely. This can result in injury to yourself or others.
Never use a harness with a defective quick release
or any other damage.
1- key ;
2- gear case ;
3- collar ring ;
4- metal blade;
5- washer;
6- washer;
7- nut
NYLON LINE (NYLON
1- Key ;
2- gear case ;
3-collar ring;
8- nylon spool
HOW TO WEAR
1. Wear the provided harness without twisted bands, with
the hanger on your right side.
(1) Hanger
BALANCE THE UNIT
1. Hook your machine to the hanger.
2. Adjust the bands of the harness to have the blade
parallel to the ground when standing in your normal
working position to provide you most effectiveness
and comfort on operating the machine.
3. In order to prevent the hanger position to change
during operation, turn up the extra part of the band
from the buckle.
4. When correctly adjusted, check the correct working
of the harnesses' QUICK RELEASE.
QUICK RELEASE
The harness is equipped with a "QUICK RELEASE"devise.
To release the machine from the harness in emergency
situations, please follow the procedure as explained
below.
WARNING
Make sure to check proper working of the QUICK RE-
LEASE device BEFORE operating the machine.
Make sure to hold the unit securely when using the
QUICK RELEASE.
While holding the unit by your right hand securely, press
both sides of the
buckle. sides of the buckle.
(1) Buckle
GB 8
(1)
(1)