Timberpro M2600-3 Manual Del Propietário página 28

8. Maintenance
Place your file on the cutter and push straightforward.
Keep the file position as illustrated.
After every cutter has been set, check the depth gauge
and file it to the proper level as illustrated.
(1) Appropriate gauge checker
(2) Make the shoulder round
(3) Depth gauge standard
WARNING
Be sure to round off the front edge to reduce the
chance of kickback or tie-strap breakage.
Make sure every cutter has the same length and edge
angles as illustrated.
(4) Cutter length
(6) Side plate angle
TRANSMISSION
The reduction gears are lubricated by multipurpose,
lithium-based grease in the transmission.
Supply new grease every 25 hours of use or more often
depending on the job condition.
When adding lubricant, use a grease gun to insert lubri-
cant into the three grease nipples located on the trans-
mission.
(1) Grease fitting
GB 26
(5) Filing angle
(7) Top plate cutting angle