Timberpro M2600-3 Manual Del Propietário página 9

5. Set up
IMPORTANT
Tighten the screws gradually by turns.
CONNECTING THROTTLE WIRE
1. Remove the air cleaner cover.
2. Connect the end of the throttle wire to the joint on the
top of the carburetor.
M3 screw
Adjuster
Insert the cable
to the end of
adjuster
Full on stopper
1. Connect throttle wire with carburetor. Insert the cable
to the end of adjuster fix the throttle cable by tighten-
ing M3 screw. (Tightening torque: 0.4 ~ 0.8 N.m.)
2. Make sure the 'STOPPER-PLATE' of carburetor moves
to contact with 'IDLING ADJUST SCREW' and the
'SWING-ARM' of carburetor moves to contact with
'FULL ON STOPPER' by gripping throttle lever.
CONNECTING SWITCH WIRES
• Connect the switch wires between the engine and the
main unit. Pair the wires of the same color.
NOTE
Position
• The recommanded position of the handle and suspen-
point is marked below. However you may also adjust
the postion to make sure it is comfortable for you.
Suspension point
Loop handle
Idling adjust screw
Installation of handle
Quick release lever
Handle
Locknut
•Insert the tube into the handle as picture showed
•Align the pin on handle into the hole on the tube,
make sure they are fully seated
•Put the the quick release lever into the hole
•Tighten the quick release lever with the locknut. ( 5
to 6 turns)
•Press down the quick release lever in the right posi-
tion (as shown in picture)
CONNECTINHG THE SHAFT
C
To connect the working shaft to the main shaft,
Loose the turning nut(A) and press
button(B).
Insert the working shaft into the connector and
release the "Push" button(B),make sure the
" Push" button locks the hole (C) on the working
shaft.
Secure the turning nut(A).
GB 7
Pin
B
A
the"Push"
Hole