Installation Steps - AVS Bugflector Instrucciones De Instalación

Installation Steps

Install (2) wellnuts on hood shield flanges using (2) machine screws and (2) washers. Tighten finger
3
Align holes in hood shield with holes in hood in order to center part
4
With the well nut inserted into hole in hood, secure hood
shield to hood by tightening screw to expand well nut.
Repeat for remaining fastener.
DO NOT OVER TIGHTEN
6
Close hood. Clean four (4) locations on the painted hood surface with an alcohol pad. Apply four (4) bump ons as indicated.
8
NOTE: Actual application may vary slightly from illustrations.
in place.
tight only at this point.
NOTE: observe the alignment from the side view in order to
guide the hood shield with its attached well nut into the proper
Hood
Hood shield
5
Insert (2) fasteners through the hood shield and into
7
Page 2 of 3
Screw
Washer
Hood shield
Well nut
hole in the hood.
the hood and securely tighten.
fastener
hood shield
hood
DO NOT OVER TIGHTEN
X2
Well Nut
Screw and
Washer
X2