Relocating Measuring Position For Supply Temperature - Bosch CRI 848H Instrucciones Para La Instalación

en 26 | CRI�CRI� ���� | Preparatory work for EPS �15
5.� Relocating measuring position for
supply temperature
i
All the items required are contained in the parts set
1 687 016 033.
1. Remove side cover for engine compartment (Pos. 1)
and for hydraulics compartment (Pos. 2).
2
Fig. 12: Side covers
2. Detach the connecting line (Pos. 3) in the engine
compartment from the temperature sensor (Pos. 4)
and route downwards into hydraulic compartment.
The connecting line is needed again for connection to
the new temperature measuring position in Step 11.
3. Turn temperature sensor (Pos. 4).
4. Turn screw plug (Pos. 5) with flat sealing ring
(12 x 15.5 mm) into threaded bore and then tighten.
3
4
5
458804-12
Fig. 13: Removing temperature sensor
|
1 689 978 562 2012-03-29
5. In the hydraulic compartment detach the hose lines
6. Remove pivoted screw fitting (Pos. 7).
1
Fig. 14:
7. Remove union nut and die ring of new pivoted screw
8. Turn pivoted screw fitting (Pos. 9) into the heat
9. Screw hose lines (Pos. 6 and Pos. 8) onto pivoted
10. Turn temperature sensor (Pos. 4) with flat sealing
11. Fit connecting line (Pos. 3) to temperature sensor
12. Mount side covers for engine and hydraulic com-
Fig. 15:
(Pos. 6 and Pos. 8) on the heat exchanger.
6
7
8
Removing pivoted screw fitting
fitting (Pos.9).
exchanger and tighten.
screw fitting and tighten.
ring (12 x 15.5 mm) into pivoted screw fitting and
then tighten.
(Pos. 5).
partments again.
3
4
6
9
8
Installing temperature sensor
Robert Bosch GmbH