EdilKamin INPELLET 49 Instalación Uso Y Mantenimiento página 27

Refer to local regulations in the country of use for anything
Local Health Authority regulations.
If the insert is to be installed in a block of apartments, con
sult the block administration before installing.
CES
The insert must NOT be installed in the same room as type B
CHECKING ELECTRICAL CONNECTION
INPELLET 49 is supplied with an electrical power lead to be
thermal magnetic switch.
line must be of a section that is appropriate to the insert power.
POSITIONING
To function correctly, INPELLET 49 must be positioned on the
level.
INPELLET 49 must be installed in compliance with the fol-
lowing safety conditions:
If it is impossible to leave the distances given above, technical
If connected to a wooden wall, or wall constructed from ano-
AIR INTAKE
with the outside. It must have a useful minimum section of
without creating depression in the installation room.
49.
outside via pipes.
The pipes must not be longer than 1 metre and have no bends
and must have a wind guard at the end.
Note:
Even in the case of direct connection, an air inlet which
connects the installation room with the outside must be set.
INSTALLATION
SMOKE DISCHARGE
The discharge system must only be used for the insert (no
hearths).
measuring 8 cm in diameter.
suitable sealed steel pipes.
The material used to seal and if necessary insulate the pipes,
must be resistant to high temperatures (high temperature silico-
ne or mastic).
The only horizontal section allowed may be up to 1 meter long,
avoiding any counter-slopes.
eaves of the roof.
insulating material.
-
CHIMNEY POT
The main characteristics are:
- an internal cross-section at the base, which is the same as that
- an outlet cross-section which is no smaller than twice that of
- its position must be high enough to catch the wind and avoid
downdraft areas in turbulent wind..
- 27
-
**
A:
B:
C:
D:
**
well-insulated for the entire length)
**
respect to horizontal
**
**