Troubleshooting - Yamaha F6A Manual Del Propietário

EMU01204¯
A problem in the fuel, compression, or ignition systems can cause poor starting, loss of
power, or other problems. The troubleshooting chart describes basic checks and possible
remedies. (This chart covers all Yamaha outboard motors. Therefore, some items may not
apply to your model.)
If your outboard motor requires repair, bring it to a Yamaha dealer.
Trouble
A. Starter will not
operate.
B. Engine will not start
(Starter operates).

TROUBLESHOOTING

Possible Cause
1. Battery capacity weak or low.
2. Battery connections loose or corroded.
3. Fuse for electric start circuit blown.
4. Starter components faulty.
5. Engine stop switch lanyard not
attached.
6. Shift lever in gear.
1. Fuel tank empty.
2. Fuel contaminated or stale.
3. Fuel filter clogged.
4. Starting procedure incorrect.
5. Fuel pump malfunctions.
6. Spark plug(s) fouled or incorrect type.
7. Spark plug cap(s) fitted incorrectly.
8. Poor connections or damaged ignition
wiring.
9. Ignition parts faulty.
10. Engine stop switch lanyard not
attached.
11. Shift lever in gear.
12. Engine inner parts damaged.
1. Check battery condition. Use battery of
recommended capacity.
2. Tighten battery cables and clean bat-
tery terminals.
3. Check for cause of electric overload
and repair. Replace fuse with one of
correct amperage.
4. Have serviced by a Yamaha dealer.
5. Attach lanyard.
6. Shift to neutral.
1. Fill tank with clean, fresh fuel.
2. Fill tank with clean, fresh fuel.
3. Clean or replace filter.
4. Read "STARTING ENGINE" section.
5. Have serviced by a Yamaha dealer.
6. Inspect spark plug(s). Clean or replace
with recommended type.
7. Check and re-fit cap(s).
8. Check wires for wear or breaks. Tighten
all loose connections. Replace worn or
broken wires.
9. Have serviced by a Yamaha dealer.
10. Attach lanyard.
11. Shift to neutral.
12. Have serviced by a Yamaha dealer.
5-1
GB
Remedy