Breaking In (Running In) Engine - Yamaha F6A Manual Del Propietário

EMU00224
BREAKING IN (RUNNING IN)
Your new engine requires a period of break-
in (running-in) to allow mating surfaces of
moving parts to wear-in evenly. Correct
break-in (running-in) will help ensure proper
performance and longer engine life.
CAUTION:
@
Failure to follow the break-in (running-in)
procedure may result in reduced engine
life or even severe engine damage.
@
Break-in (running-in) time: 10 hours
EMU00233¯
Run the engine under load (in gear with a
propeller installed) as follows.
1) For the first hour of operation:
Run the engine at 2,000 r/min or at
approximately half throttle.
2) For the second hour of operation:
Run the engine at 3,000 r/min or at
approximately three-quarter throttle, and
during this period run it at full throttle for
approximately one minute every ten
minutes.
3) For the next eight hours of operation:
Avoid continuous operation at full throt-
tle for more than five minutes at a time.
4) After these first 10 hours:
Operate the engine normally.
3-9
ENGINE
GB