After-Sales Service; E Number And Fd Number; Technical Data - NEFF C54L60W0 Instrucciones De Uso

Problem
It takes longer than before for the
food to heat up.
A signal sounds. The colon in the
display is flashing.
Error messages
You can take remedial action yourself for some error
messages.
Error message
Error message "E723" appears in the dis-
play.
Error message "Er1", "Er4", "Er18" or "E305"
appears in the display.
Error message "Er11" appears in the dis-
play. "Button jammed"

After-sales service

Our after-sales service is there for you if your appliance needs
to be repaired. We will always find the right solution in order to
avoid unnecessary visits from a service technician.

E number and FD number

When calling us, please give the product number (E no.) and
the production number (FD no.) so that we can provide you with
the correct advice. The rating plate bearing these numbers can
be found on the right-hand side when you open the appliance
door. To save time, you can make a note of the number of your
appliance and the telephone number of the after-sales service
in the space below, should it be required.
E no.
After-sales service O
Please note that there will be a fee for a visit by a service
technician in the event of a malfunction, even during the
warranty period.
Please find the contact data of all countries in the enclosed
customer service list.
To book an engineer visit and product advice
0844 8928989
GB
Calls from a BT landline will be charged at up to
3 pence per minute. A call set-up fee of up to 6 pence
may apply.
01450 2655
IE
Trust the expertise of the manufacturer, and rest assured that
the repair will be carried out by trained service technicians
using original spare parts for your domestic appliance.
This appliance corresponds to the standards EN 55011 and
CISPR 11. It is a Group 2, Class B product.
Possible cause
The microwave power setting is too low.
A larger amount than usual has been
placed in the appliance.
The food was colder than usual.
The appliance is in demonstration mode.
Possible cause
The door is not properly closed.
Technical malfunction.
The buttons are dirty or the mechanism
has jammed.
FD no.
Remedy/information
Select a higher power setting.
Double the amount = almost double the time
Stir or turn food during cooking.
Press the
1.
Press and hold the
2.
The demonstration mode is deactivated.
Remedy/Note
Open the appliance with the
close it again.
Call the after­sales service.
Press all the buttons several times. Clean
the buttons with a dry cloth. Open and
close the appliance door. If this does not
help, consult the after-sales service.
Group 2 means that microwaves are produced for the purpose
of heating food. Class B states that the appliance is suitable for
private households.

Technical data

Power supply
Maximum total connected load 1220 W
Microwave power setting
Microwave frequency
Fuse
Dimensions (HxWxD)
­ appliance
­ cooking compartment
VDE approved
CE mark
°±² button.
o button for 3 seconds.
button and
3
230 V, 50 Hz
900 W (IEC 60705)
2,450 MHz
min. 10 A
382 mm x 595 mmx 320 mm
220 mm x 350 mm x 270 mm
yes
yes
27