Kingston DataTraveler 2000 Manual De Instrucciones página 10

To continue with changing the User PIN, please follow the steps located in the table below.
Instructions
1. Press KEY button once
2. Within 10 seconds, start to enter the
User PIN (default - 11223344) to
unlock the DT2000
3. Press KEY button once
4. Press the KEY button twice (double-
click)
5. Within 10 seconds, begin to enter
the new User PIN
6. Press the KEY button twice (double-
click)
7. Within 10 seconds, begin to re-enter
the new User PIN
8. Press the KEY button twice (double-
click)
If you make a mistake while defining a new User PIN or do not complete the procedure,
Note:
the drive will retain the old
Document No. 480ADT2000.B00
LED
PIN.
LED State
&
Red, Green Blue
once and then the
LED will continue to blink
Red
solid LED changes to
Red
indicating successful default User PIN entry
LED blinks
Blue
LED continues to blink
Blue
LED blinks
Green
LED continues to blink
Green
solid LED changes to
Red
indicating that the User PIN change was
successful
DT2000
LEDs will flash together
LED will continue to blink
Red
solid LED
Green
solid LED,
Green
Page 9 of 30