Enable Read/Write In Admin Mode - Kingston DataTraveler 2000 Manual De Instrucciones

Enable Read/Write in Admin Mode

Admin can override User set Read-Only by enabling Read/Write on the DT2000 using the Admin PIN.
To set the DT2000 to Read/Write, follow the steps in the table below.
Only do these steps when DT2000 is disconnected from a Host system.
Note:
Entering the Admin PIN to access a locked drive will clear the User PIN. For security
Caution:
reasons, we highly recommend that a new User PIN be created immediately once the drive
has been unlocked using the Admin PIN. Refer to
Instructions
1. Unlock the DT2000 with Admin PIN
2. Press the KEY button three times
(triple-click)
3. Within 10 seconds begin to press the
number 7 (pqRs) button followed by
the number 9 (Wxyz) button (79)
4. Press KEY button once
Document No. 480ADT2000.B00
LED
Creating a New User PIN in Admin
LED State
solid LED followed by a flickering
Red
LED indicating successful Admin PIN entry
and LEDs flicker together
Green Blue
and LEDs continue to flicker together
Green Blue
solid LED changing to flickering
Red
when the DT2000 is inserted into a USB port the
LED is solid indicating the DT2000 is
Green
Read/Write enabled
DT2000
Mode.
Green
LED.
Green
Page 19 of 30