Verify Whether An Admin/User Pin Has Been Created; Enable Read-Only In Admin Mode - Kingston DataTraveler 2000 Manual De Instrucciones

Verify Whether an Admin/User PIN Has Been Created

The following table illustrates how to determine which PINs, User and/or Admin, have been created.
With the DT2000 in a locked state (all LEDs off), press the KEY button once
& LEDs will flash together once and then one of the following states will occur.
Red, Green Blue
Definition
Only User/default PIN exists
Only Admin PIN exists
Both User and Admin PIN's exist

Enable Read-Only in Admin Mode

When an Admin writes content to the DT2000 and restricts access to read-only, the User cannot change this
setting in User mode. To set the DT2000 to Read-Only, follow the steps in the table below.
Only do these steps when DT2000 is disconnected from a Host system.
Note:
Caution:
reasons, we highly recommend that a new User PIN be created immediately once the drive
has been unlocked using the Admin PIN. Refer to
Instructions
1. Unlock the DT2000 with Admin PIN
2. Press the KEY button three times
(triple-click)
3. Within 10 seconds begin to press the
number 7 (pqRs) button followed by
the number 6 (mnO) button (76)
4. Press KEY button once
Document No. 480ADT2000.B00
Entering the Admin PIN to access a locked drive will clear the User PIN. For security
LED LED State
LED blinks
Red
LED blinks
Blue
and
Red Blue
Creating a New User PIN in Admin
LED LED State
solid LED followed by a flickering
Red
LED indicating successful Admin PIN entry
and
Green Blue
and
Green Blue
solid LED changing to flickering
Red
when the DT2000 is inserted into a USB port the
LED blinks every two seconds indicating
Green
the DT2000 is in Read-Only mode
DT2000
LEDs blink together
Green
LEDs flicker together
LEDs continue to flicker together
Green
Mode.
LED.
Page 18 of 30