Create A New User Pin In Admin Mode - Kingston DataTraveler 2000 Manual De Instrucciones

Create a New User PIN in Admin Mode

Creating a new User PIN in Admin mode will become necessary if the DT2000 has been unlocked for any
reason with the Admin PIN, as this will automatically clear the User PIN.
User PIN requirements:
Must be between 7-15 digits in length
o
Must not contain only repetitive numbers, e.g. (3-3-3-3-3-3-3)
o
o Must not contain only consecutive numbers, e.g.
To create a new User PIN in Admin mode please follow the instructions on the table below.
Only do these steps when DT2000 is disconnected from a Host system.
Note:
Instructions
1. Unlock the DT2000 with Admin PIN
2. Press the KEY button twice (double-
click)
3. Within 10 seconds begin to enter your
New User PIN
4. Press KEY button twice (double-
click)
5. Within 10 seconds begin to re-enter
the New User PIN
6. Press KEY button twice (double-
click)
Document No. 480ADT2000.B00
LED
(1-2-3-4-5-6-7), (7-8-9-0-1-2-3-4), (7-6-5-4-3-2-1)
LED State
solid LED followed by a flickering
Red
indicating successful Admin PIN entry
LED blinking ready to receive new PIN
Blue
LED continues to blink
Blue
LED blinks
Green
LED continues to blink
Green
LED quickly fades out to indicate successful
Red
creation of a New User PIN
DT2000
LED
Green
Page 16 of 30