Unlock The Dt2000 As Admin - Kingston DataTraveler 2000 Manual De Instrucciones

Unlock the DT2000 as Admin

Entering the Admin PIN to access a locked drive will clear the User PIN. For security
Caution:
reasons, we highly recommend that a new User PIN be created immediately once the drive
has been unlocked using the Admin PIN. Refer to
To continue unlocking the DT2000 as Admin, follow the steps in the table below.
Only do these steps when DT2000 is disconnected from a Host system.
Note:
Instructions
1. Press and hold down the number 1
button and press the KEY button
once (1 & )
2. Within 10 seconds begin to enter
your Admin PIN
3. Press the KEY button once
Once the DT2000 has been successfully unlocked, the
Note:
seconds only, during which time the DT2000 needs to be connected to a USB port. It can be
locked down immediately by pressing and holding down the KEY button for 3 seconds, or waiting
for the 30 seconds to expire or by clicking the "Safely Remove Hardware / Eject" icon within your
operating system.
Document No. 480ADT2000.B00
LED
Creating a New User PIN in Admin
LED State
and LEDs flicker together
Red Green
and LEDs continue to flicker
Red Green
together
solid LED followed by a flickering
Red
LED indicating successful Admin PIN entry
Green
DT2000
Mode.
Green
LED will remain on for 30
Page 15 of 30