Wilo Atmos GIGA-N Instrucciones De Instalación Y Funcionamiento página 54

en
5.2.1 Attaching the pump
Fig. 3: Attaching the pump
5.2.2 Attaching the unit
Fig. 4: Attaching the unit
54
Transportation and storage
CAUTION
Property damage due to incorrect transport
To ensure proper alignment, all equipment is pre-assembled. If dropped or if im-
properly handled, there is a risk of misalignment or deficient performance due to de-
formations. The pipes and valves will not withstand loads and should not be used to
secure loads in transit.
• Only use permitted lifting gear for transport. Ensure the stability of the load since,
with this particular pump design, the centre of gravity is shifted to the top (top-
heavy).
• Never attach lifting gear to shafts in order to lift the unit.
• Do not use the transport lugs on the pump or motor to lift the entire unit. They are
only meant for transporting the individual components during installation or dis-
mantling.
Only remove the outer packaging at the place of utilisation to ensure that the pump is
not damaged during transport.
CAUTION
Risk of damage due to incorrect packaging.
If the pump is transported again at a later date, it must be packaged so that it cannot
be damaged during transport. Use the original packaging for this, or choose equival-
ent packaging.
▪ Comply with applicable national safety regulations.
▪ Use legally specified and approved lifting gear.
▪ Select the lifting gear based on the prevailing conditions (weather, attachment point,
load, etc.).
▪ Only attach the lifting gear to the attachment point. Fix in place with a shackle.
▪ Never feed the lifting gear over or through transport lugs without protection.
▪ Never feed the lifting gear over sharp edges without protection.
▪ Use lifting equipment with sufficient bearing capacity.
▪ The stability of the lifting equipment must be ensured during operation.
▪ When using lifting equipment, ensure a second person is present to coordinate the pro-
cedure if required (e.g. if the operator's field of vision is blocked).
▪ When lifting, make sure that the load limit of the lifting gear is reduced when pulling at
an angle. The safety and efficiency of the lifting gear is best guaranteed when all load-
bearing elements are loaded vertically. If necessary, use a lifting arm, to which the lift-
ing gear can be vertically attached.
▪ Ensure the load is lifted vertically!
▪ Prevent the suspended load from swinging!
▪ Comply with applicable national safety regulations.
▪ Use legally specified and approved lifting gear.
▪ Select the lifting gear based on the prevailing conditions (weather, attachment point,
load, etc.).
▪ Only attach the lifting gear to the attachment point. Fix in place with a shackle.
▪ Never feed the lifting gear over or through transport lugs without protection.
▪ Never feed the lifting gear over sharp edges without protection.
▪ Use lifting equipment with sufficient bearing capacity.
▪ The stability of the lifting equipment must be ensured during operation.
▪ When using lifting equipment, ensure a second person is present to coordinate the pro-
cedure if required (e.g. if the operator's field of vision is blocked).
▪ When lifting, make sure that the load limit of the lifting gear is reduced when pulling at
an angle. The safety and efficiency of the lifting gear is best guaranteed when all load-
bearing elements are loaded vertically. If necessary, use a lifting arm, to which the lift-
ing gear can be vertically attached.
▪ Ensure the load is lifted vertically!
▪ Prevent the suspended load from swinging!
WILO SE 2019-04