Transportation And Storage; Delivery; Transport - Wilo Atmos GIGA-N Instrucciones De Instalación Y Funcionamiento

5

Transportation and storage

5.1

Delivery

5.2

Transport

Installation and operating instructions Wilo-Atmos GIGA-N
Transportation and storage
If not all working loads reach the maximum permitted values, one of these loads may
exceed the normal limit value. This is under the condition that the following additional
conditions are fulfilled:
▪ All force and torque components are limited to 1.4 times the maximum permitted value.
▪ The forces and torques acting on each flange meet the requirements of the compensa-
tion equation.
Fig. 2: Compensation equation
Σ F and Σ M are the arithmetic sums of the effective values of both pump
effective effective
flanges (inlet and outlet). Σ F
maximum permitted values of both pump flanges (inlet and outlet). The algebraic signs
of Σ F and Σ M are not taken into consideration in the compensation equation.
The pump is secured to a pallet ex works and is protected against dirt and moisture.
Check the shipment immediately on receipt for defects (damage, completeness). De-
fects must be noted on the freight documentation. Any defects must be notified to the
transport company or the manufacturer immediately on the day of receipt of shipment.
Subsequently notified defects can no longer be asserted.
DANGER
Risk of fatal injury due to suspended loads!
Never allow anyone to stand under suspended loads! Danger of (serious) injuries
caused by falling parts. Loads may not be carried over work places where people are
present!
The safety zone must be marked so that there is no danger when the load (or part of
it) slips away or if the lifting device snaps or is ripped off.
Loads must never be suspended for longer than necessary.
Accelerations and braking during the lifting operation must be performed in a way
that rules out any danger to people.
WARNING
Hand and foot injuries due to lack of protective equipment!
Danger of (serious) injuries during work. Wear the following protective equipment:
• Safety shoes
• Safety gloves for protection against cuts
• Sealed safety goggles
• Safety helmet must be worn if lifting equipment is used!
NOTICE
Use only properly functioning lifting equipment!
Use only properly functioning lifting equipment to lift and lower the pump. Ensure
that the pump does not become jammed during lifting and lowering. Do not exceed
the maximum bearing capacity of the lifting equipment! Check that lifting equip-
ment is functioning properly before use!
and Σ M are the arithmetic sums of the
max. permitted max. permitted
en
53