Installation Steps
Insert visor into window channel,
rear flange first. Rear flange inserts
between the trim and the exterior
suraface. The front & top flange
slides into the window channel.
3
Press the exposed area of tape against the surface and
verify position.
5
4 Piece Set
Install the rear visor using the same preparation and installation methods as front visor. Note
that the top & rear flanges slide into the window channel, and the front flange fits between the
7
Care and Cleaning
• Wash only with mild soap & dry with a clean cloth.
Congratulations!
You have purchased one of the many quality Auto Ventshade™ branded products offered by Lund International, Inc. We take the utmost pride in our
products and want you to enjoy years of satisfaction from your investment. We have made every effort to ensure that your product is top quality in
terms of fit, durability, finish and ease of installation.
™
Auto Ventshade
NOTE: Actual application may vary slightly from illustrations.
Repeat steps 1 thru 7 for passenger side
Lund International
800-241-7219 • Visit us at lundinternational.com
© 2015 Lund International, Inc. All rights reserved.
, the Auto Ventshade
logo and the AVS
TM
TM
Remove tape liner by pulling on free ends.
4
Continue to apply pressure to ensure that the visor
remains properly seated inside the window channel
as window is slowly closed. Leave window up for 72
hours to secure visor to window channel.
72
50°F / 10°C Min.
6
rubber & window frame.
logo are trademarks of Lund International, Inc.
TM
Page 2 of 2