Publicidad
ASSEMBLING THE REDUCTION GEAR - ASSEMBLAGGIO RIDUTTORE - REDUZIERER ZUSAMMENBAUEN - ASEMBLAJE REDUCTOR -
32
GB
Using a plastic hammer, install bearing (32)
26
25
GB
Heat bearing (26) to about 90 Ê C and install to input shaft (25).
NOTE. Make sure that bearing rests properly against shaft.
45
GB
Fit gearshift fork (23) to sleeve yoke (45) and install the complete
intermediate shaft (22) in reduction gear casing (52).
ASSEMBLAGE REDUCTEUR
DNF00490
a
DNF00510
c
22
23
52
DNF00530
e
36
29
30
GB
Coat flange face (31) and install; lock flange with screws (30) and
spring washers (29) and tighten them to 50 Nm using the criss-
cross method.
GB
Using a plastic hammer, install input shaft (25) in reduction gear
casing (52).
20
GB
Using an appropriate driver, install inner ring of bearing (51) to
output shaft (20).
31
DNF00500
b
25
52
DNF00520
d
51
DNF00540
f
Publicidad
