Wall-Mounting The Switch - Allied Telesis AT-GS900/5E Guia De Instalacion

Wall-Mounting the Switch

The AT-GS900/xE switch can be mounted horizontally on a wall using the
two keyhole slots in the bottom of the switch.
To mount an AT-GS900/xE switch onto a wall, perform the following
procedure:
1. Remove all equipment from the package and store the packaging
material in a safe place.
2. If attached, remove the rubber feet, data cables, and power cord from
the switch.
3. Select a wall location for the switch.
4. Mark two hole locations on the wall.
5. At the marked locations for the holes, pre-drill for the drywall anchors
and drive the screws through the holes.
6. Align the switch horizontally, as illustrated in Figure 8..
Figure 8. Aligning an AT-GS900/8E for Wallmount Installation
AT-GS900/xE Gigabit Ethernet Switch Installation Guide
1041
29