Publicidad
Idiomas disponibles
Idiomas disponibles
MAChiNE OVErViEw
1
3
5
1. ON/OFF TriggEr SwiTCh
2. AuXiLiAry FrONT hANDLE
3. DiSChArgE EXhAuST POrT
4. LOwEr BLADE guArD
5. FiTTED BLADE iN SiTu
14
www.evolutionpowertools.com
2
4
www.evolutionpowertools.com
gETTiNg STArTED - PrEPArATiON
wArNiNg: Always disconnect the saw from the
power source before making any adjustments.
This saw is equipped with an approved mains lead and plug
for its intended country of use. Do not alter or modify the
mains lead.
iNSTALLiNg/rEMOViNg A BLADE
wArNiNg: Only use genuine Evolution blades which are designed
for this machine. Ensure that the maximum speed of the blade is
compatible with the machine. Only perform this operation with
the machine disconnected from the power supply.
Note: It is recommended that the operator considers wearing
protective gloves when handling the blade during installation
or when changing the machine's blade.
• Place saw on a level, secure surface.
• Remove the chip collector from the machine by undoing the
(2) large thumb screws. (Fig. 1)
Note: The chip collector thumb screws are 'captive' and cannot
be removed from the machine.
• Lock the machine arbor by engaging the arbor lock. (Fig. 2)
• Using the supplied hex key loosen and remove the arbor
socket headed screw and outer blade drive flange. (Fig. 3)
Note: The socket headed arbor screw has a right hand thread.
• Remove the saw blade, leaving the inner blade flange in its
service position.
• Thoroughly clean inner and outer blade drive flanges and
blade mounting surface before installing a new blade.
15
EN
Fig. 1
ES
Fig. 2
FR
Fig. 3
TR
Publicidad
