Publicidad
Idiomas disponibles
Idiomas disponibles
• Ensure that the direction of rotation arrows printed on the
blade match the direction of rotation arrow found on the
chip collector. (Fig. 4)
• Reinstall the outer drive flange and the arbor socket
headed screw.
• Engage the arbor lock and tighten the arbor socket headed
screw securely using the hex key.
• Replace the chip collector and securely tighten the
two thumb screws.
• Check that the arbor lock is fully released by manually
Fig. 4
rotating the blade.
• Check the operation of the lower blade guard.
Parallel Edge guide
A parallel guide (for help when rip cutting) can be fitted to the
base plate of the machine. The guide's arms should be inserted
into the rectangular slots in the turned up edges of the sole
plate, and slid under the locking thumb screws. (Fig. 5)
Note: The parallel edge guide can be fitted to either side of
the sole plate and should only be fitted and adjusted with the
machine disconnected from the power supply.
Fig. 5
Adjust the parallel edge guide so that it is at the required
distance from the blade and tighten the two thumb screws.
Check that the parallel edge guide is parallel to the saw blade.
(b)
Auxiliary handle (Fig. 6)
The Auxiliary Handle (supplied) can be screwed into a threaded
boss found to the front left hand side, slightly above the
machine's motor (b), or into the boss found on the bevel
locking quadrant (a).
(a)
This handle will provide the operator with a convenient position
Fig. 6
for their left (or right) hand during cutting operations.
16
www.evolutionpowertools.com
www.evolutionpowertools.com
Adjustment of the Cutting Depth
Release the lever lock (Fig. 7) to adjust to the required cutting
depth. Adjust the cutting depth to the thickness of the
workpiece. Less than a full tooth of the blade teeth should be
visible below the workpiece.
Note: Always check to see if there are any obstructions below the
work surface that could influence the setting of the cutting depth.
Tighten the lever lock securely to lock in the required position.
Adjustment of the Cutting Angle
• Loosen the bevel locking screw found at the front of the saw.
• Loosen the rear bevel locking screw found at the rear of the
machines sole plate.
• Tilt the saw body to the required angle (Fig. 8).
• Tighten both bevel locking screws securely.
Note: An angle scale (0
– 45
) is incorporated into the bevel
0
0
locking quadrant to aid setting.
OPErATiNg ADViCE
Carry out routine safety checks each time you use the machine.
Check that all safety guards are operating correctly, and that all
adjustment handles/screws are tightened securely.
Check that the blade is secure and installed correctly. Also check
that it is the correct blade for the material being cut.
Check the integrity of the power cord.
Always clamp the workpiece to a rigid support such as a bench
or saw horse whenever possible.
ON/OFF Trigger Switch (Fig. 9)
This machine is equipped with a safety start trigger switch.
To start the machine:
• Push in the safety lock button on the side of the handle with
your thumb.
• Depress the main trigger switch to start the motor.
wArNiNg: Never start the saw with the cutting edge of
the saw blade in contact with the workpiece surface.
17
EN
Fig. 7
ES
Fig. 8
FR
Fig. 9
TR
Publicidad
