Pull Chain Operation Instructions - Harbor Breeze LP8007LABN Manual Del Usuario

HOUSING SWITCH CUP/ADAPTER ASSEMBLY (Continued)
2. Remove one of the three screws in the support bracket.
Slightly loosen the remaining two screws. Assemble the
adapter assembly (B) to the housing support bracket (A) using
the two key slots in the adapter assembly. Replace the third
screw and securely tighten all three screws. (Fig. 20)
3. Securely attach the 9-pin switch cup connector to the wiring
harness socket within the adapter assembly. (Fig. 21)
4. Install the housing switch cup (B) onto the
assembled adapter with the three screws removed in
step 1 of the previous page. (Fig. 22)
PULL CHAIN OPERATING INSTRUCTIONS
1. Restore electrical power to the outlet box by turning the
electricity on at the main fuse box. (Fig. 23)
2. Check the operation of the fan by gently pulling on the pull
chain switch. (Fig. 24)
Pull Chain Operating Sequence
1 Pull High
st
2 Pull Medium
nd
Low
3 Pull
rd
Off
4 Pull
th
3. If airflow is desired in the opposite direction, turn the fan off and
wait for the blades to stop turning. Then slide the reverse switch
to the opposite position and turn fan on again. Your fan model is
equipped with a 4-position, 3-speed, pull chain switch. (Fig. 25)
Reverse Switch Information
Season Rotation Direction
Summer Counter-Clockwise
Winter Clockwise
Switch Position
Right
Left
10
Fig. 20
A
Fig. 21
Fig. 22
B
Fig. 23
ON ON
ON ON
ON ON
ON ON
Fig. 24
Fig. 25
B