Assembly Instructions - Harbor Breeze LP8007LABN Manual Del Usuario

ASSEMBLY INSTRUCTIONS

1. Remove the hanger ball portion from the
downrod/hangerball assembly (D) by loosening the set screw
in the hanger ball until the ball falls freely down the downrod.
Remove the pin from the downrod, then remove the hanger
ball. Retain the pin and hanger ball for reinstallation in Step 4.
(Fig. 1)
2. Loosen the two set screws in the downrod support of the
motor assembly (A). Route the black, white and blue wires
through the downrod. (Fig. 2)
3. Thread the downrod into the downrod support on top of the
motor. Install the clevis pin by aligning the holes in the
downrod support with holes in the downrod. Secure clevis pin
with hairpin clip. Tighten the two set screws with nuts in the
downrod support. (Fig. 3)
It is critical that the clevis pin in the downrod
WARNING:
support is properly installed and the set screws and nuts are
securely tightened. Failure to do so could result in the fan falling.
4. Route wires through Motor Coupling Cover (G), Canopy
Screw Cover (F) and Canopy (E). (Fig. 4)
5. Reinstall the hanger ball on the downrod (D) as follows.
Route the three 54 in. wires through the hanger ball. Position
the pin through the two holes in the downrod and align the
hanger ball so the pin is captured in the groove in the top of
the hanger ball. Pull the hanger ball up tight against the pin.
Securely tighten the set screw in the hanger ball. A loose set
screw could create fan wobble. (Fig. 5)
6. Cut off excess lead wire approximately 6 to 9 inches above
top of the top of the downrod. Strip insulation off 1/2 inch from
the end of each lead wire. (Fig. 6)
Hanger
A
Pin Hole
A
6
Fig. 1
Pin
Ball
Set Screw
D
Fig. 2
D
Fig. 3
Downrod
D
Support
set screw
and nut (2)
Clevis
Fig. 4
E
F
G
Fig. 5
D
Fig. 6