Installation Steps; Care And Cleaning - AVS Ventvisor Instrucciones De Instalación

Installation Steps

Insert visor into window channel, rear flange first.
Insert rear flange between rubber trim and door post.
Insert front flange into window channel. The top flange
slides into the window channel.
3
Press the exposed area of tape against the surface and
verify position.
5
4 Piece Set
Insert visor into window channel, front flange first. Insert front flange between rubber trim and
door post. Insert rear flange into window channel. The top flange slides into the window channel.
7

Care and Cleaning

• Wash only with mild soap & dry with a clean cloth.
Congratulations!
You have purchased one of the many quality Auto Ventshade™ branded products offered by Lund International, Inc. We take the utmost
pride in our products and want you to enjoy years of satisfaction from your investment. We have made every effort to ensure that your
product is top quality in terms of fit, durability, finish and ease of installation.
™ Auto Ventshade
NOTE: Actual application may vary slightly from illustrations.
Repeat steps 1 thru 7 for passenger side
Lund International
800-241-7219 • Visit us at lundinternational.com
© 2016 Lund International, Inc. All rights reserved.
, the Auto Ventshade logo and the AVS
TM TM
Remove tape liner by pulling on free ends.
4
Continue to apply pressure to ensure that the visor
remains properly seated inside the window channel as
window is slowly closed. Leave window up for 72 hours
to secure visor to window channel.
72
50°F / 10°C Min.
6
logo are trademarks of Lund International, Inc.
TM
Page 2 of 2