Publicidad
Idiomas disponibles
Idiomas disponibles
10
34. Center the heat shrink tubing (2) over
the solder joint and heat using a heat
gun. Heat the joint until the tubing is
tightly sealed and sealant (1) comes out
of both ends of the tubing.
35. Install the PDC to its original mounting
location by aligning the retaining clips
with the PDC bracket and pressing
down.
36. Confirm the retaining clips (1) are fully
engaged in the PDC mounting bracket.
March 5, 2014
www.mopar.com
K6861692AB
Publicidad
