Mopar 82213752AB Instrucciones De Montaje página 4

4
11. Position the new handle and the latch
control to the tailgate.
12. Install the two nuts that secure the
release handle and latch control to
the tailgate. Tighten the nuts to 6 N·m
(53 in. lbs.).
NOTE: If equipped with a power lock
actuator, remove and discard
the lock actuator harness.
13. Connect the supplied camera harness
(E) to the camera and connect the
supplied tailgate jumper harness (1).
NOTE: Tape back the lock
actuator connector if vehicle
is not equipped with a lock
actuator.
14. Connect the lock actuator connector (1)
(if equipped).
March 5, 2014
www.mopar.com
K6861692AB