Descargar Imprimir esta página

Mopar 82213752AB Instrucciones De Montaje página 7

Publicidad

Idiomas disponibles

Idiomas disponibles

NOTE: When routing the body
harness, make sure the
harness cannot contact any
moving parts or hot exhaust.
22. Route the supplied body harness (C)
from the back of the vehicle to the front
as shown, following the existing
harness on the driver side.
23. Attach the supplied body harness to the
existing harness with the supplied tie
straps. Tie straps must be used
every 150mm to properly secure the
supplied harness.
24. Remove the ground bolt (2) located on
the left fender next to the Power
Distribution Center (PDC).
25. Connect the black wire in the supplied
body harness (C) to the ground location
on the fender.
26. Install the ground bolt (2). Tighten the
ground bolt to 9 N·m (80 in. lbs.).
27. Release the PDC retaining clips (1) and
remove the PDC from the mounting
bracket.
March 5, 2014
www.mopar.com
7
K6861692AB

Publicidad

loading