Manufactured (Mobile) Home Installation - Alliance Laundry Systems LES33A Instrucciones De Instalación

Manufactured (Mobile) Home
The dryer can be installed in a manufactured (mobile)
home by following these instructions:
1. IMPORTANT: Gas dryers MUST be
permanently attached to the floor at the time of
installation. Order No. 526P3 Dryer Installation
Kit for a manufactured (mobile) home
installation. Follow the instructions supplied
with the kit.
2. Electrical Connections (Electric Dryer Only) must
be a 4-wire connection, refer to page 13.
3. Venting—Dryer MUST be exhausted to the
outdoors.
WARNING
To reduce the risk of fire and combustion
gas accumulation, the dryer MUST BE
EXHAUSTED TO THE OUTDOORS. Refer to
Section on Dryer Exhaust Requirements.
• The dryer can be exhausted to the outdoors through
the back, left, right or bottom panel. Gas dryers
cannot be exhausted out the left side because of the
burner housing.
• The dryer exhaust duct must be secured to the
mobile home structure.
• Exhaust ducts MUST NOT be connected with sheet
metal screws or fasteners which extend into the duct.
• Exhaust duct must not be connected to any other
duct, vent or chimney.
504607
Installation . . .
IMPORTANT: Installation must conform to
the Manufactured Home Construction and
Safety Standards, Title 24 CFR, Part 32-80 or
Standard CAN/CSA-Z240 MH.
W047
• Dryer exhaust duct MUST NOT terminate under the
mobile home.
• For proper operation, it is important that the dryer
has an ample amount of outside make-up air. The
free area of any opening for the introduction of
outside air must be at least 25 in
• When exhausting the dryer to the outdoors, the dryer
can be installed with "0" inch clearance at the sides
and rear. Clearance of the duct from combustible
construction must be a minimum of 2 inches (5.08
cm).
• Venting materials are not supplied with the dryer
(obtain locally).
WARNING
To reduce the risk of fire, the exhaust duct
and weather hood MUST be fabricated of a
material that will not support combustion.
Rigid or flexible metal pipe is recommended
for a clothes dryer.
2 2
(163 cm ).
W048
11