Instructions For Maintenance; Reminders For The Maintenance Technician; Commissioning; Troubleshooting - Gastrodomus LM8T43 Instalación, Uso, Mantenimiento

Do not use direct or high pressure water jets to clean
the appliance.
SATIN FINISH STAINLESS STEEL SURFACES
Clean the surfaces with a cloth or sponge using water
and proprietary non-abrasive detergents. Follow the
direction of the satin finish lines. Rinse repeatedly
and dry thoroughly.
Do not use pan scourers or other iron items.
Do not use chemical products containing chlorine.
Do not use sharp objects which might scratch and
damage the surfaces.
INSTRUCTIONS FOR
V.
MAINTENANCE
12. REMINDERS FOR THE
MAINTENANCE TECHNICIAN
THE MANUFACTURER WILL NOT BE LIABLE
FOR ANY DAMAGE OR INJURY RESULTING
FROM FAILURE TO OBSERVING THE
FOLLOWING RULES.
Identify the specific appliance model. The model
number is detailed on the packing and on the
appliance dataplate.
The appliance must be installed in a well-ventilated
room.
Do not tamper with appliance components.

13. COMMISSIONING

See Chapter " Instructions for installation ".

14. TROUBLESHOOTING

PROOFER
THE APPLIANCE DOES NOT HEAT.
Possible causes:
- Temperature thermostat defective.
- Heating elements defective.
HEATING CANNOT BE ADJUSTED
Possible causes:
- Temperature thermostat defective.

15. REPLACING COMPONENTS

REMINDERS FOR REPLACING COMPONENTS
SHUT THE GAS SHUT-OFF VALVE AND/OR
SWITCH THE APPLIANCE OFF AT THE
MAIN SWITCH INSTALLED UPSTREAM.
DISCONNECT THE APPLIANCE ELECTRIC
SUPPLY, IF PRESENT, BEFORE CARRYING
OUT ANY OPERATION.
AFTER REPLACING AN ELECTRICAL
SYSTEM COMPONENT, CHECK IT IS
CORRECTLY WIRED.
PROOFER
REPLACING THE HEATING ELEMENT
- Remove the basin from the equipment bottom.
- Remove set screws.
- Disassemble electrical box cover.
- Remove and replace the component.
- Reassemble all parts. For assembly, proceed in
reverse order.
REPLACING THE WORKING THERMOSTAT.
- Remove the control panel.
- Remove the bulb from its seat and replace the faulty
part.
- Remove and replace the component.
- Reassemble all parts. For assembly, proceed in
reverse order.

16. CLEANING THE INTERIOR

- Check the condition of the inside of the appliance.
- Remove any built-up dirt.
- Clean accurately the basin to avoid the development
of internal corrosion deposits.
15