Controls & Features - LCT 136cc Serie Manual De Instrucciones

Controls & Features
CONTROLS
1. Choke Control Knob
The Choke Control Knob opens and closes the choke valve in the carburetor.
The "START" position enriches the fuel mixture which allows easier starting
a cold engine. The "RUN" position provides the correct fuel mixture once
engine warms up. Never try to shut the engine down using the Choke Control
Knob.
2. Idle-Down Control Ring (if equipped) (not shown)
The Idle-Down Control Ring sets engine speed from high-speed to low-
speed. Rotate the ring clockwise, "RUN" position for high-speed. This control
MUST be set in the "RUN" position for starting a cold engine. By rotating the
ring counterclockwise, "IDLE" position, will allow your engine to run at low-
speed. DO NOT OPERATE EQUIPMENT IN THE IDLE POSITION. Note: the
idle-down control is intended to be either in "RUN" or "IDLE" positions only.
3. Engine RUN/STOP Rocker Switch
The Engine Rocker Switch enables and disables the ignition system. Turn
the engine switch to the RUN position to start the engine. Turn the Engine
Rocker Switch to the STOP position to stop the engine.
3A. Keyed Run/Stop Switch
The Keyed Run/Stop Switch enables and disables the ignition system. Turn
the engine's key switch to the RUN position to enable the engine to start and
run. Turn the Engine's key switch to the STOP position to stop the engine.
Remove the key for SAFETY to prevent non-supervised operation.
4. Fuel Control Knob
The Fuel Control Knob opens and closes the passage between the fuel tank
and carburetor. The Fuel Control Knob must be in the "ON" position for the
engine to run. When the engine is not in use, be sure to turn the Fuel Control
Knob to the "OFF" position.
5. Safety Key Switch
The Safety Key Switch enables the engine electrical system and must be
installed to start the engine.
6. Primer Bulb
The Primer Bulb system is designed to enrichen the fuel mixture for starting a
cold engine. DO NOT over prime the fuel system. To properly use the Primer
Bulb system, depress Primer Bulb 3 times maximum when starting a cold
engine. Do not use Primer Bulb system when attempting to start a warm
engine.
7. Oversized Recoil Handle
The engine is started by pulling the Recoil Handle. Always grip
firmly and have your body positioned p operly when pulling.
When starting the engine:
· Slowly pull Recoil Handle until resistance is felt.
· Then pull firmly the full length of the ope to start engine.
· Never wrap thumb around Recoil Handle in the event of
engine kick-back.
8. Oversized Gas Cap
Allows for easy opening and closing for more efficient refueling.
9. Electric Start (if equipped)
Used to start the engine with 120VAC extension cord. Always use correct
size extension cord to prevent electric starter damage.
10. High Oil Fill Tube
Allows convenient location for adding oil during the life of the engine. Check
oil level with lower oil fill plug (10a) or upper fill (10) if equipped per owner's
manual instructions.
11. Oil Drain
The oil drain can be located on either side and on some models extend out below the recoil housing.
2 1
3
6
5
2 1
3A
6
GEN II 136cc / 179cc / 208cc / 254cc / 291cc / 306cc / 369cc / 414cc Snow Engine Manual 4
8
7
4
11
8
7
4
11
10
9
10a
10
9
10a