Publicidad
Idiomas disponibles
Idiomas disponibles
ISO DIN radio provision with pocket
1. Remove the metal DIN sleeve and trim ring from
the aftermarket radio.
2. Attach the radio brackets to the radio using
the screws supplied with the radio. (Figure A)
3. Attach the pocket to the radio bracket
assembly using (4) #8 x 3/8" Phillips truss
head screws supplied. (Figure A)
4. Locate the factory wiring harness and
antenna connector in the dash and complete
all necessary connections to the radio and
climate controls. Metra recommends using the
proper mating adapter from Metra or AXXESS.
Re-connect the negative battery terminal and
test the radio for proper operation.
5. Mount the completed assembly into the dash
using screws removed in disassembly.
6. Snap the radio trim panel over the completed
assembly, and then reassemble the dash in
reverse order of disassembly. (Figure B)
METRA. The World's best kits.
Installation instructions for part 99-7345B
Kit Assembly
(Figure A)
(Figure B)
metraonline.com
™
IMPORTANT
If you are having difficulties with the
installation of this product, please call our
Tech Support line at 1-800-253-TECH.
Before doing so, look over the instructions a
second time, and make sure the installation
was performed exactly as the instructions
are stated. Please have the vehicle apart
and ready to perform troubleshooting steps
before calling.
K
NOWLEDGE IS
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
Metra recommends MECP
certified technicians
© COPYRIGHT 2004-2015 METRA ELECTRONICS CORPORATION
P
OWER
Publicidad
