Cleaning The Hook-In Racks; Troubleshooting; Replacing The Oven Light Bulb - NEFF B9481N3 Manual Del Usuario

Fitting the appliance door
When hooking in the oven door, ensure that the notch on the
1.
bottom of the hinge locks into the slot.
Fold down both locking levers on the left and right again and
2.
close the oven door.
:
Risk of injury!
Do not reach into the hinge if the oven door falls out
unintentionally or a hinge snaps closed. Call the after­sales
service.

Cleaning the hook-in racks

You can remove the hook-in racks for easier cleaning.
The hook-in racks in each case are fixed to the side walls of the
cooking compartment at three points.

Troubleshooting

Malfunctions often have simple explanations. Please read the
following notes before calling the after­sales service.
Problem Possible cause Notes/remedy
The appliance Circuit breaker
does not work. faulty.
Power cut
The oven can- The electronics
not be switched are faulty.
off.
The clock dis- Power cut
play flashes.
The oven does Circuit breaker
not heat up. faulty.
The function
selector has not
been set.
The door glass
is broken.
Fruit juice or Moist cake or
albumen stains meat juices.
on enamelled
surfaces.
:
Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be carried
out by one of our trained after-sales engineers.
Incorrect repairs may result in significant risk to the user.
10
Look in the fuse box and
check that the circuit
breaker for the cooker is in
working order.
Check whether the kitchen
light works.
Switch off the circuit
breaker. Contact the after-
sales service.
Reset the clock.
Check the circuit breaker
and replace if necessary.
Set the function selector.
Switch off the appliance.
Contact the after-sales serv-
ice.
Harmless change in the
enamel, cannot be
removed.
Removing the hook-in racks
Lift the front hook A out of the hole.
1.
Pull the hook-in rack forwards out of the rear holes B.
2.
Cleaning the hook-in racks
Clean the hook-in racks with washing-up liquid and a sponge or
brush.
Inserting the hook-in rack
Insert the hook-in rack into the holes in the back wall.
1.
Hook the front hook into the hole.
2.

Replacing the oven light bulb

If the bulb in the oven light fails, it must be replaced.
Replacement heat-resistant bulbs can be obtained from the
after-sales service or from specialist retailers. Please supply
your appliance's E number and FD number. Do not use any
other type of bulb.
Switch off the appliance at the circuit breaker or pull out the
1.
mains plug.
Open the appliance door.
2.
Lay a tea towel in the cold cooking compartment to prevent
3.
damage.
Unscrew the glass cover from the defective oven light bulb
4.
inside the cooking compartment by turning it anti-clockwise.
Replace the oven light bulb with one of the same type.
5.
Voltage: 240 V;
Power: 25 W;
Thread: E14;
Temperature resistance: 300 °C
Screw the glass cover of the oven light bulb back on.
6.
Remove the tea towel and switch the circuit breaker back on
7.
or plug in the mains plug.
Press the function button for the oven lighting until it locks into
place in order to check whether the oven lighting is working
properly.