Sanyo SPWXDR124GH56A Manual Del Usuario página 104

11. HOW TO INSTALL THE WIRELESS REMOTE CONTROLLER RECEIVER
■ RCS-SH80AG.WLB for 4-Way Cassette (X Type)
11-1. Installing the Receiver Unit
The only corner where the receiver unit can be
GB
installed is the one shown in Fig. 11-1. Therefore, con-
sider the direction of the panel when it is installed on
the indoor unit.
(1) Remove the intake grille.
FR
(2) Remove the screws that fasten the adjustable
corner cap, then slide the adjustable corner cap to
the side to remove it. (Fig. 11-2)
DE
(3) The square hole used for the panel wiring is
filled with packing (sponge material) used for
insulation.* Remove the packing, then pass the
wiring from the wireless receiver unit through
IT
the grill. Twist the wires together and use a cable
fastener to fasten them and attach with a screw,
then replace the packing in the hole as it was
before. (Fig. 11-3)
PT
* If this packing is not used, there is danger of
condensation on the wiring. Be sure to replace the
packing.
(4) After completing wiring as described in "Wiring the
GR
Receiver Unit" on the next page, twist the wires
together and use a cable fastener to fasten them,
leaving a length of wiring that is long enough to
permit removal of the adjustable corner cap.
ES
(Fig. 11-3)
(5) Install the receiver unit in the panel. At this time,
slide the receiver unit so that each of the 3 tabs
fits into its respective hole. Take care that the wires
are not pinched. (Fig. 11-4)
* Refer to the instruction manual provided with the
panel.
NOTE
●
Do not twist the control wiring together with the
power wiring because this may cause a malfunc-
tion.
●
Install a noise filter or take other appropriate action
if electrical noise affects the power supply circuit of
the unit.
* For wiring and test run procedures, refer to "Wiring
the Receiver Unit" and "Test Run".
DC̲Inverter̲Eng.indd 104 DC̲Inverter̲Eng.indd 104
Indoor unit
drain tube side
Indoor unit electrical
components box
Fig. 11-1
Adjustable corner cap
screw
Fig. 11-2
Remove the packing, twist
the wires together and fasten
them with the cable fastener.
Then replace the packing.
Fig. 11-3
Fig. 11-4
104
Indoor unit
refrigerant tube side
Receiver unit
installation position
(Right side of electrical
components box)
Ceiling panel
Adjustable corner cap
2007/07/25 13:21:54 2007/07/25 13:21:54