Wiring The Ceiling Panel; How To Attach The Corner & Air Intake Grille - Sanyo SPWXDR124GH56A Manual Del Usuario

9-3. Wiring the Ceiling Panel

(1) Open the cover of the electrical component box.
(2) Connect the 7P wiring connector (red) from the
ceiling panel to the connector in the unit electrical
component box.
GB
●
If the connectors are not connected, the auto flap
will not operate. Be sure to connect them securely.
●
Check that the wiring connector is not caught
FR
between the electrical component box and the
cover.
●
Check that the wiring connector is not caught
between the unit and the ceiling panel.
DE
9-4. How to Attach the Corner and Air Intake Grille
Attaching the corner cover and air-intake grille
A. Attaching the corner cover
IT
(1) Check that the safety cord from the corner cover is
fastened to the ceiling panel pin, as shown in the
figure.
PT (2) Use the supplied screws to attach the corner cover
to the ceiling panel.
B. Attaching the air-intake grille
●
To install the air-intake grille, follow the steps for
GR
Removing the grille in the reverse order. By rotat-
ing the air-intake grille, it is possible to attach the
grille onto the ceiling panel from any of 4 directions.
Coordinate the directions of the air-intake grilles
ES
when installing multiple units, and change the
directions according to customer requests.
●
When attaching the air-intake grille, be careful
that the flap lead wire does not become caught.
●
Be sure to attach the safety cord to the ceiling
panel unit as shown in the figure at right. This
keeps the air intake grille from accidentally
dropping.
●
With this ceiling panel, the directions of the air-intake grille lattices when installing multiple units, and the position
of the label showing the company name on the corner panel, can be changed according to customer requests,
as shown in the figure below. However, the optional wireless receiver kit can only be installed at the refrigerant-
tubing corner of the ceiling unit.
Locations of the air-intake grille catches at
the time the product is shipped.
* The grille can be installed with these
catches facing in any of 4 directions.
Unit electrical component box
DC̲Inverter̲Eng.indd 64 DC̲Inverter̲Eng.indd 64
(Direction that the unit faces has been changed to
facilitate explanation.)
Screws
(3 locations)
Mains side
Clamp
* Pass the wiring connector through the clamp to fasten it in place,
as shown in the figure.
Hole for ceiling panel hook
Unit drain hose side
Unit refrigerant tube side
Optional wireless receiver kit
* Can only be installed
in this position.
Fig. 9-15
64
Electrical component
box cover
Ceiling panel side
Fig. 9-12
Pin
Place the corner cover so that the 3 tabs
fit into the holes in the ceiling panel.
Then fasten it in place with the supplied screws.
Fig. 9-13
Hook that prevents
the grille from dropping
Fig. 9-14
Can be installed rotated 90˚
Ceiling panel
wiring connector
2007/07/25 13:21:48 2007/07/25 13:21:48