Sanyo SPWXDR124GH56A Manual Del Usuario página 110

Tabla de contenido

Publicidad

■ RCS-BH80AG.WLB for U Type
11-11. Accessories Supplied with Separate
Receiver Unit
No.
Part
GB
Separate
receiver unit
1
(provided 200mm
power cable)
Plate
FR
mounting
2
Screws
3
M4 × 25
Screws
4
DE
M4 × 40
Wood
5
screws
IT
11-12. Important Information for Installation of
1 Separate Receiver Unit
<Installation location>
Do not install in a location where the air contains oil
PT
mist, such as in a kitchen or factory.
Do not install next to a window, or in any other
location directly exposed to sunlight and outside air.
Do not install nearby devices which can be expect-
GR
ed to produce electrical noise, such as elevators,
automatic doors, and industrial sewing machines.
If the receiver unit is installed near a rapid-start
type or inverter-type fluorescent lamp (excluding
ES
glow lamp), it may not be possible to receive the
wireless remote controller signal in some cases.
In order to prevent interference from fluorescent
lamps, leave a minimum of
2 m between the receiver unit and the fluorescent
lamps, and install the receiver unit in a location
where it can receive the wireless remote controller
signal when the fluorescent lamps are lit.
11-13. How to Install the Separate Receiver Unit
NOTE
To avoid malfunction of the remote controller, do
not assemble or run remote control wiring together
with the power cables, and do not enclose them in
the same metal conduit.
When the power unit induces electrical noise, it
is recommended that a noise filter or the like be
installed.
DC̲Inverter̲Eng.indd 110
DC̲Inverter̲Eng.indd 110
Q'ty
Part
No.
Spacer
6
1
Wire joints
7
1
Clamp
8
Pattern template
9
95 × 51
2
2
2
Q'ty
4
2
1
1
Receiver unit
Screws
M4 × 25 (2)
1
2
3
4
5
6
Remove
Face plate
Fig. 11-13
110
Spacer
2007/07/25 13:21:56
2007/07/25 13:21:56

Publicidad

Tabla de contenido
loading

Tabla de contenido