Initial Instructions; Important; Downrod Style Fan Mounting - Harbor Breeze LARALYN LRN32 Manual Del Usuario

INITIAL INSTRUCTIONS

1. Determine mounting method to use.
A - Downrod Mount (standard or angled ceiling)
B - Closemount (standard ceiling only)
IMPORTANT: lf using the angle mount, check
to make sure the ceiling angle is not steeper
than 20°.
2. Remove the three rubber motor stoppers (O)
from the underside of the fan motor assembly
(H). Discard the preassembled motor blocks
and the rubber motor stoppers (O).
3. Remove the two non-slotted screws on
canopy (B) and save, then loosen the two
slotted screws. Remove mounting bracket (A)
from canopy (B).
1
A
B
2
O
H
3
Remove
Loosen but do
and save
not remove
A
B
6
INITIAL INSTRUCTIONS
4. Install the mounting bracket (A) to the outlet box
(not included), sliding the mounting bracket (A)
over the two outlet box screws (not included).
Securely tighten the two outlet box screws.
IMPORTANT: If using the angle mount, make
sure open end of mounting bracket (A) is
installed facing the ceiling.
Depending on the mounting method (A or
B) chosen in Step 1, either refer below for
"Downrod Style Mounting" or proceed to
page 9 for "Closemount- Style Mounting".

DOWNROD STYLE FAN MOUNTING

1. Remove preassembled pin and clip from
downrod (E) and save.
2. Insert downrod (E) through canopy (B),
canopy cover (C), and yoke cover (D).
Thread wires from the motor housing
assembly (H) through downrod (E).
4
Outlet box
1
clip
pin
2
B
D
7
A
E
E
C