Installation Steps - AVS Bugflector Instrucciones De Instalación

Installation Steps

Clean the area around holes and the flat mounting loca-
tion above the mesh gill with alcohol pads.
3
Align hood shield to center of hood. Press firmly on
exposed tape to secure position.
5
With hood shield in its final position, remove remaining
tape liner by pulling on free ends.
7
9
NOTE: Actual application may vary slightly from illustrations.
Apply (4) bump ons to surface of hood.
Expose 2" (5 cm) of tape liner from each end of the flanges
4
Align hood previously removed fasteners with slots in
hood shield and holes in hood. Press firmly to reinstall
6
Apply firm pressure along all taped flanges to ensure
8
Page 2 of 3
on the hood shield.
fastners.
adhesion.