Installation Steps; Care And Cleaning - AVS Ventvisor Deflector Instrucciones De Instalación

Installation Steps

Remove tape line from rear end flange. Expose 2" (5
cm) of tape from each end of top flange.
free end
top flange
rear
flange
2
The upper lip of the visor will slide under the rubber
door seal.
slide under door
seal
visor
4
With the visor in its final position, remove remaining
tape liner by pulling on free ends.
6

Care and Cleaning

• Wash only with mild soap & dry with a clean cloth.
Congratulations!
You have purchased one of the many quality Auto Ventshade™ branded products offered by Lund International, Inc. We take the utmost pride in our
products and want you to enjoy years of satisfaction from your investment. We have made every effort to ensure that your product is top quality in
terms of fit, durability, finish and ease of installation.
Auto Ventshade
™
NOTE: Actual application may vary slightly from illustrations.
free end
front
flange
Close-up
tape
window
Lund International, Ventshade Accessories Division
655 Raco Drive, Lawrenceville, GA 30045
800-241-7219 • Fax 770-339-5839 • Visit us at lundinternational.com
© 2005 Lund International, Inc. All rights reserved.
, the Auto Ventshade logo and the AVS
TM TM
Position the driver side visor on the previously prepared
surface. The front and top flanges attach directly to
the rubber channel on the outside of the door. The rear
flange attaches to the vertical plastic cap.
3
Verify proper positioning, and gently press on exposed
areas of tape to secure in place.
5
Apply pressure along flange edges to ensure adhesion
and secure visor in place
7
Repeat Steps 1-7 for passenger side visor
logo are trademarks of Lund International, Inc.
TM
Page 2 of 2