Low Battery Warning - RIDGID NaviTrack Scout Manual Del Usuario

Turn the unit off by depressing and releasing the Power key on
the keypad. Be aware there is a delay of a few seconds
while turning on/off the unit.

4.4 Low Battery Warning

When the battery gets low, a battery icon will appear in the
map area on the screen. This indicates that the batteries need
to be changed and that the unit will soon shut down.
Just before complete shut down there will be a non-interrupt-
able power down sequence.
In some cases the voltage on rechargeable batteries may drop
so quickly that the unit will just shut down. The unit will turn off
and restart. Just replace the batteries and turn the unit back on.
5. Set up
Once the Scout is up and running the next step is to set up the
frequencies needed that match the equipment to be located.
Each is activated for use by selecting them from a list in the
menu.
1. Push the menu key, highlight the selection, then press
the select key to activate:
2. Using the up and down arrows highlight a frequency to
match the one used in the sonde or on the line trans-
mitter, then press the select key to check the box. See
the Menu Choices for reference. Hit the menu key to
return to the main screen.
Warning! – Be sure that the frequency selected matches the
desired use. 512 and 33 are available as a sonde AND a line
trace frequency. Using a sonde frequency for line tracing or
vice versa, can cause the Scout to display incorrect depth
information.
3. Now press the sonde/trace/frequency mode key to
cycle through the activated frequencies and modes.
Pay attention to the icons on the screen to see which
mode the Scout is operating in.
4. If the depth, auto backlight or LCD contrast needs to be
adjusted then highlight the selection in the tools section
of the menu and make changes using the select key.
5.1 Menu Choices
128
7